1997 Ezgo 36 volt Series just clicks. Will not spin wheels at all. Did a lot of testing with the DVOM but finally just threw a bunch of parts at it. I have another EZGO that does work so I just parted it out. Things I know.
Batteries good. 6 months old. Each around 6.3 volts. All tied together about 38.7 volts. I changed out controller, F&R switch, solenoid, inductive coil. No change. I tested the motor according to a chart I found on this website with a 12 volt booster pack and motor tested good. I used a test light to check the connections between each battery(because sometimes DVOMs show voltage where there is little current) and no problems. What am I missing here??? It's like the power just drops to nothing like I have a bad connection that won't allow enough current to get through but I cant figure out where. Any suggestions?Thanks
Batteries good. 6 months old. Each around 6.3 volts. All tied together about 38.7 volts. I changed out controller, F&R switch, solenoid, inductive coil. No change. I tested the motor according to a chart I found on this website with a 12 volt booster pack and motor tested good. I used a test light to check the connections between each battery(because sometimes DVOMs show voltage where there is little current) and no problems. What am I missing here??? It's like the power just drops to nothing like I have a bad connection that won't allow enough current to get through but I cant figure out where. Any suggestions?Thanks