Hi folks,
My injection does not work on my ,90 GX444, I was told it was disconnected but have not had the pleasure of delving into the where and how of that yet.
While I am not pro-injection, I do eventually want to see what's up with it.
To the point, I have been mixing fuel/oil at approximately 35-40/1 and know that won't hurt anything much.
The question is; What would be a good mix for the single GP3?
I am aware that the injection system will adjust to certain conditions as the engine operates, so a fixed mix may not be accurate in certain conditions.
With my past experiences with engines when it comes to mixing, the mixes mostly lay between 25/1 and 50/1 depending again on what type and use the engine goes through.
My average of 35-40/1 should be safe enough but maybe someone might have a better result/experience, and to me, there is always room for improvement of thinking.
(Carts perish for the lack of owner experience :mrgreen:)
Anyone?
Thanks E.Z.
My injection does not work on my ,90 GX444, I was told it was disconnected but have not had the pleasure of delving into the where and how of that yet.
While I am not pro-injection, I do eventually want to see what's up with it.
To the point, I have been mixing fuel/oil at approximately 35-40/1 and know that won't hurt anything much.
The question is; What would be a good mix for the single GP3?
I am aware that the injection system will adjust to certain conditions as the engine operates, so a fixed mix may not be accurate in certain conditions.
With my past experiences with engines when it comes to mixing, the mixes mostly lay between 25/1 and 50/1 depending again on what type and use the engine goes through.
My average of 35-40/1 should be safe enough but maybe someone might have a better result/experience, and to me, there is always room for improvement of thinking.
(Carts perish for the lack of owner experience :mrgreen:)
Anyone?
Thanks E.Z.