I have a EZ-Go shuttle 6 with a Curtis 1264-5407 controller. The cart wont move. everything comes on and even in run mode you can push the cart and the regen braking comes on. The weird thing is if you switch from run->Tow then back the cart will run for 2-3 sec then the solenoid will dis-engage. The controller will flash 5-5 meaning a solenoid issues, however I tested it and it works fine no issues. I did notice the if I put a DVM between the feed from the controller to engage the solenoid I get nothing. I check the ITS/pedal switch and all other voltages are good. I am thinking a bad controller at this point, any suggestions?
↧