The cart SN is AQ0224-155876 and has a D&D Motor. It will run OK for a few minutes then fail to barely able to move. The alltrax has a harness converter board to fit the cart harness. The batteries are good and the charger works. I used my controller pro software and the controller is set right but the throttle position will go from 100 to 13 %. I replaced the MCOR and it ran about 15 minutes normally and then went to hardly moving and no power. So far I can't find a harness issue. I don't believe the Alltrax uses a speed sensor all though the motor has one. Help!
↧