Hello all, I just picked up a Taylor Dunn Burden Cart Model B2-48 36Volt. It doesn't have batteries in it so I used a diagram I found on this wonderful site to verify that the motor does in fact turn over. All of the motor cables were disconnected and two of the lugs had a big jumper between them so I don't know if the previous owner was trying to test the motor, or operate it on 12 volts only.
I have 6 large gage cables in back by the motor and battery compartment. Red and Black are longer so I assume they went to the batteries. The last four are Blue Green Yellow and White. I see 4 labels on the Motor: A1 A2 S1 S2.
Would anybody happen to have a wiring diagram they could post or PM me?
The serial number of this unit is 128458 which according to T/D makes it a 1998 model. It does look like the motor has been messed with though because there is sloppy RTV goop between the motor and gear drive housing.
Thanks in advance for any help.
Tom
I have 6 large gage cables in back by the motor and battery compartment. Red and Black are longer so I assume they went to the batteries. The last four are Blue Green Yellow and White. I see 4 labels on the Motor: A1 A2 S1 S2.
Would anybody happen to have a wiring diagram they could post or PM me?
The serial number of this unit is 128458 which according to T/D makes it a 1998 model. It does look like the motor has been messed with though because there is sloppy RTV goop between the motor and gear drive housing.
Thanks in advance for any help.
Tom