I recently purchased a 2011 EZGO Sport 2+2 and in the process of replacing batteries. This is a 48v cart that comes from the factory with head light/tail lights and horn. While I was in the process of removing the cables there was a green wire on the positive terminal of the middle battery on the row closest to the back of the cart. This looks like it is a part of the original wiring harness. The terminal broke off as I was removing the wire from the post, so I'll have to put a new terminal on it. Since this if part of the original harness I have no idea if I have enough slack just to put a new terminal or have to splice additional wire onto it. Does anybody have any idea what this wire is for. With my limited knowledge of electric golf carts I have no idea if this is part of a 8 volt assessory (scratching my head on that one), or is part of the total 48volt system. It's part of a group of wires that lead from the fuse block to the front of the cart. The best I can tell the green wire is much larger than the other wires on the fuse block, it has a push on spade at the end closest to the fuse block but it not connected to anything.
To summerize my question. I have a green wire hooked up to the positive terminal on the middle battery of the row of batteries closest to the back. The other end looks like it terminates at the fuse block, but is not hooked up. This is part of the factory wiring harness and I'm trying to figure out what this green wire is.
To summerize my question. I have a green wire hooked up to the positive terminal on the middle battery of the row of batteries closest to the back. The other end looks like it terminates at the fuse block, but is not hooked up. This is part of the factory wiring harness and I'm trying to figure out what this green wire is.