Thanks in advance, this is a great site with a wealth of information. This is my first cart that I recently purchased that came with a 6" lift with 22×11-10 duro tires and a folding rear seat. Of course I melted the vglide and a poorly connected wire on th f/r switch. I purchased a new 400mzj 36/48 solenoid,wiper brush and arm from Scottyb and some welding cable locally. I plan on doing the wot vglide bypass and installing the #2 cables on everything but the ones that run from the vglide to the resistors. Do I need a resistor or diode on the solenoid I'm adding ? Where is the best place to source 2 gauge cable ends ? With this setup can I haul my family of 4 up some fairly steep grades without melting something or do I need to go ahead and plan on switching the cart over to a solid state 500 amp controller ? Thanks again
↧