I have a 96 ezgo non dcs I haven't been able to get to run yet. I have checked many things on this cart and am using the Ezgo factory manual to trouble shoot it.
I have new batteries, a "good used" controller, a new ITS, all the micro switches work, tested continuity on control wires.
I'm at the point where, if you jump battery voltage across the solenoid, the cart runs in forward and reverse, and speeds up and slows down with the foot throttle. Without the jumper there is nothing.
I keep stopping in the diagnostic tree at the ITS. I had two used ones, and bought a new one and they all fail the test the same way. They show 13.8v when they should be 14-15, and when the 4pin connnector is disconnected the voltage goes to 14.1v.
Has anyone ever ran into this ?
I have new batteries, a "good used" controller, a new ITS, all the micro switches work, tested continuity on control wires.
I'm at the point where, if you jump battery voltage across the solenoid, the cart runs in forward and reverse, and speeds up and slows down with the foot throttle. Without the jumper there is nothing.
I keep stopping in the diagnostic tree at the ITS. I had two used ones, and bought a new one and they all fail the test the same way. They show 13.8v when they should be 14-15, and when the 4pin connnector is disconnected the voltage goes to 14.1v.
Has anyone ever ran into this ?