Started working on my 48v conversion this afternoon. Built my own set of 1/0 gauge cables using welding wire "scraps" I bought on Ebay and terminals I bought on Ebay (have not built the cables that go from controller to motor and from F&R to controller/solenoid yet - see below). Total cost about $40. 2 issues right now that are basically "space" issues. I had lithium in my cart but bms screwed up and my daughter went under voltage multiple times (despite the digital voltmeter on dash) and the batteries just don't hold a charge any more. I don't think my onboard charger and 12v accessory battery will fit together under the driver's side part of the seat so I may move the battery to the passenger side. Problem is, where do I mount my Alltrax SPM48500? Unlike most of you, I actually use the cart for golf so the rear well is out. Other option is getting a 48 -12v reducer but I don't think I can get one of them locally and want to finish the project tommorow. Any suggestions are welcome. Thanks
↧