I am going to mount a LED light bar on my txt.
I have a separate 12 Volt battery and fuse block.
The LED is a 72 watt bar.
1) what size gauge wires
2) I need an on off switch that I will mount down by my legs next to FR lever on DCS cart. I want just a simple switch, are these switches rated by amps?
3) I have an existing switch in the same place for my front and rear lights. Can I tie into that switch and run all the lights? Can you over load a switch?
Thx
Skip
Sent from my Nexus 6 using Tapatalk
I have a separate 12 Volt battery and fuse block.
The LED is a 72 watt bar.
1) what size gauge wires
2) I need an on off switch that I will mount down by my legs next to FR lever on DCS cart. I want just a simple switch, are these switches rated by amps?
3) I have an existing switch in the same place for my front and rear lights. Can I tie into that switch and run all the lights? Can you over load a switch?
Thx
Skip
Sent from my Nexus 6 using Tapatalk