Ok I know this is a question that's been around a while, but mine must be different right?
2003 txt...valves good, comp around 190, new carb, lifted w/22" tires, new plugs,..etc.
Cruising along on flat...riding 4 of us around...no problem...runs great.
10 mins in...starts to smell like its heating up...not oil or gas smell...some will know right away what smell I'm talking about...then try to go up a small incline.
Engine won't rev...cart says nope...3 get off and up I go...not large people either. It stopped and I could not start going again until they got off...and it was still slower than normal. Pulled choke and it didn't help...engine/fuel doesn't seem to be the problem. It bogged down like I was trying to pull a stump out...so don't think the belt is slipping....like I said I couldn't get the engine to rev.
Before I got dropping cash on clutches...is there a way to function check the ezgo clutches ? They look like they are in good shape, not worn, and in neutral look like they are working fine...I'm no expert so I don't know if what I'm seeing is normal.
Sorry for the long winded post, but I did a bunch of searching and tried to answer some questions before they were asked. I tried to find videos of clutches working, but not much out there.
Anyone have any ideas? Much appreciated.
Red
2003 txt...valves good, comp around 190, new carb, lifted w/22" tires, new plugs,..etc.
Cruising along on flat...riding 4 of us around...no problem...runs great.
10 mins in...starts to smell like its heating up...not oil or gas smell...some will know right away what smell I'm talking about...then try to go up a small incline.
Engine won't rev...cart says nope...3 get off and up I go...not large people either. It stopped and I could not start going again until they got off...and it was still slower than normal. Pulled choke and it didn't help...engine/fuel doesn't seem to be the problem. It bogged down like I was trying to pull a stump out...so don't think the belt is slipping....like I said I couldn't get the engine to rev.
Before I got dropping cash on clutches...is there a way to function check the ezgo clutches ? They look like they are in good shape, not worn, and in neutral look like they are working fine...I'm no expert so I don't know if what I'm seeing is normal.
Sorry for the long winded post, but I did a bunch of searching and tried to answer some questions before they were asked. I tried to find videos of clutches working, but not much out there.
Anyone have any ideas? Much appreciated.
Red