I have finally gotten around to replacing both the primary and secondary sliding sheaves as well as install a new belt on my 1982 G1. With the new parts on the cart I'm now having problems. 1). See picture below...this is a cut sheave from CPP and I noticed the sheave will not push the belt any higher for a lower gear. 2). The belt is soo tight that I cannot push the cart anymore. It also is trying to start under a load so the starter is struggling. It will eventually turn over and run with just me on it but if you add another person the cart will not start because the starter cannot turn over under force. It is also lurching every time the starter spins over. Both clutches look like they're working properly when I have the rear end up on jackstands. Is this normal? Will it go away after a break in period?:help:
↧