I don't know what I did wrong, but I messed something up. All I get is forward. No reverse - whether my toggle switch is in the ON or OFF position. I even disconnected the switch. Forward. Connected the 2 wires together. Forward. Checked continuity of switch and it's working.
All of the main wires are 4 gauge, crimped, soldered, and heat shrink tubing added. The red switch wire is 12 gauge, crimped, soldered, and tubed.
The red wire on the photo (see below) goes to the toggle switch and then to the gas pedal micro switch on the KEY SWITCH side. I labeled everything else. Any ideas? How can I test with my multimeter to make sure the solenoids are working? Help please!
![]()
All of the main wires are 4 gauge, crimped, soldered, and heat shrink tubing added. The red switch wire is 12 gauge, crimped, soldered, and tubed.
The red wire on the photo (see below) goes to the toggle switch and then to the gas pedal micro switch on the KEY SWITCH side. I labeled everything else. Any ideas? How can I test with my multimeter to make sure the solenoids are working? Help please!
