Hell0 - this is my first post. I am completely new to everything golf carts, however, I have spent a fair amount of time researching and learning on the fly.
I have a 36 V 2007 EXGO TXT and have done following modifications thus far:
- 6" Jakes lift kit with 14" rims and 23" tires
- Installed high speed motor (AMD 7126, AKA "The Raptor")
- Installed Alltrax 650 amp controller (AXE4865)
- Installed 400 "super duty" solenoid from Carts Unlimited
- New 2g wiring
- New "super duty" reversing contactor from Carts Unlimited
I have spent a lot of time trying to connecting all the wires involved in the above setup. I do not know how to read wiring diagrams and would greatly appreciate any straight forward (non-technical) feedback on the below questions/comments that I would like to confirm before I attempt to turn on:
- There are 3 wires coming out of charger receptacle (one thinner red wire, one thicker black wire and one thicker white wire). I have this red wire connected to a thin blue wire that appears to be running to ignition area. I have the white wire going to the Batt +, which is connected to new fuse on battery terminal. The black wire going to Batt -.
- there is another set of 4 wires coming from throttle area. They are green, black, white and pink/red. I have the pink/red wire going to pin 1 on controller, black to pin 2, white to pin 3. Didn't connect pin 4 for 1/2 speed reverse. I connected this green wire to another green wire which was next to the above referenced blue wire coming from ignition area.
- I connected the new wire going from neutral pin on F/R switch to small positive post on solenoid. I do not have any other wires going to the small + or - posts on solenoid. I am unclear as to what other wires go to either + or - small posts on solenoid.
I am happy to add pictures if helpful in answering the above questions.
Thank you
I have a 36 V 2007 EXGO TXT and have done following modifications thus far:
- 6" Jakes lift kit with 14" rims and 23" tires
- Installed high speed motor (AMD 7126, AKA "The Raptor")
- Installed Alltrax 650 amp controller (AXE4865)
- Installed 400 "super duty" solenoid from Carts Unlimited
- New 2g wiring
- New "super duty" reversing contactor from Carts Unlimited
I have spent a lot of time trying to connecting all the wires involved in the above setup. I do not know how to read wiring diagrams and would greatly appreciate any straight forward (non-technical) feedback on the below questions/comments that I would like to confirm before I attempt to turn on:
- There are 3 wires coming out of charger receptacle (one thinner red wire, one thicker black wire and one thicker white wire). I have this red wire connected to a thin blue wire that appears to be running to ignition area. I have the white wire going to the Batt +, which is connected to new fuse on battery terminal. The black wire going to Batt -.
- there is another set of 4 wires coming from throttle area. They are green, black, white and pink/red. I have the pink/red wire going to pin 1 on controller, black to pin 2, white to pin 3. Didn't connect pin 4 for 1/2 speed reverse. I connected this green wire to another green wire which was next to the above referenced blue wire coming from ignition area.
- I connected the new wire going from neutral pin on F/R switch to small positive post on solenoid. I do not have any other wires going to the small + or - posts on solenoid. I am unclear as to what other wires go to either + or - small posts on solenoid.
I am happy to add pictures if helpful in answering the above questions.
Thank you