Club Car stuttering after deep water
I have a 1998 48 volt Club Car DS. After driving into some deep water and cart had to be pushed out because it stopped working, it ran again once out of said deep water. Cart drove normal for about...
View Article2002 ez go pds controller for sale
Just removed from my 2002 ez go today 36v PDS controller labeled "Curtis PMC" p/n 73326G04 s/n 2113-p107380. Will fit in a $12 priority box with plenty of packing material around. Not sure what these...
View Articleforward/reverse
my 99 ezgo suddenly goes into reverse while driving. Then there is only reverse and no forward
View ArticleIs it common for the studs to be too short after changing wheels.
I bought some 14" wheels for my 95 ezgo. When I put them on, the studs are just too short to be safe. Will any parts store have this, or is it a specialty lug? I'm also having trouble getting the dust...
View Article4 cycle clutch on 3pg
Was wondering the differences between the 4 cycle and 3pg drive(primary) clutches are. I have 3pg with wore out sheave. Don't want to spend $400 on an aftermarket clutch and can't seem to find a used...
View Article48v Club Car DS has 6 - 6 volt batteries
Just bought an '03 DS. Serial number indicates 48v (starts with AQ), motor voltage says 48v. It has 6 GC-2 batteries (NAPA) which from what I read are 6v... I have a 48v cart running on 36v? Will this...
View Articlenew controler install now (forward and reverse are backwards)need help
just finished installing alltrax xct400 controller on my 2010 cc iq pds . IT WORKS BUT now my forward /reverse switch is working backwards. checked wirring several times, it is correct with alltrax...
View ArticleNew alltrax controller, new motor and noid, no go
04 ds club car. Just installed dcx500 alltrax controller, 500 amp d&d motor, sw180 solenoid and 4ga wires. Drove the cart in the shop, was 100% stock. Switched out the parts above and now it won't...
View ArticleExtreme Front End Play, Steering wheel not centered
My 92 DS has an extreme amount of front end play and the steering wheel is about 90 degrees out, Slack is not very noticeable when cart is sitting still, slight movements of the steering wheel can be...
View ArticleName of this part?
Anybody know the name or the part number for the plastic rubbery piece that goes between the windshield now and the front of the cart so it doesn't scratch or chafe against the paint? Need to buy...
View ArticleWTB: 1995 gas ezgo starter/generator
WTB: 1995 gas ezgo starter/generator Let me know what you got, thanks!
View ArticleWhat year for controller cart
I have read ezgo started using controllers on their carts as early as 1989(special order),I have someone with a 1988 with controller,what motor should be on this cart in order to work? Did he try to...
View ArticleG9 rear seat, home-made
I bought my '93 G9 for $500. and with a few inexpensive purchases she was looking pretty sharp. I wanted to add a rear seat but the choices are slim pickings and pretty darn pricey to boot. Since I own...
View ArticleNew Memeber...New Cart
Greetings all, I'm new to the golf cart world, hope to learn a lot here. Here is my 15' Club Car XRT 850 Attachment 125371 Attached Images club car.jpg (301.5 KB)
View Article3 wheeled EZ-GO lift help
I'd like to put a mild lift on a 1987 ez-go three wheeler I just bought, maybe 3 inches. The rear looks easy, some blocks should work there. The front is where I have questions. I've seen a few threads...
View ArticleRearend leakage Ez go
Lifted Ez go cart is spitting oil out of vent tube on top reared axle housing anybody had this trouble
View ArticleTesting Batteries w Volt Meter
A couple of questions concerning voltage testing batteries with a DC voltmeter. I will be testing eight series-connected 6-volt batteries in a 48Volt Bad Boy Buggy. Do I need to unhook any battery...
View Article06 bad boy buggy stopped working
I have an 06 bad boy buggy that has new batteries less than a year old. It was working fine for my wife. She uses it as a mobile landscaping vehicle. She pulled up to a flower bed and when she went to...
View ArticleSpirit 5000 swap, gearing and top speed
SOOOOOO, This all started with an extra G1 chassis I had after buying two carts to make one. THEN scored a Arctic Cat with a Spirit 5000 in it for 100$!!!!!! So with the stock rear and driven pulley in...
View ArticleMaster Drive PDS 350 amp controller
This is a perfect working condition Master Drive 350 amp 36 volt controller with White Rodgers solenoid and solenoid mount. Came off of my 2008 EZGO PDS cart that I just converted to alltrax and 42...
View Article