v glide
Any ideas of where to find replacement parts for this? the other half is fine, i just need the wiper arm and brush. Its a 97 btw. Attached Images IMG_20160116_182047608.jpg (200.5 KB)...
View Articlepower wise charger and small generator
what would happen if the power wise 21 amp charger was plugged into a small 900 watt generator? would it damage the charger? would it choke down the generator. or would it work but take a long time to...
View Articlemuffler cleaning
how often should you burn your muffler out and what is the best way? a man told me he cut a hole in the muffler and get it hot with a torch and hit it with compressed air and it cleared it out. others...
View ArticleZip Tie Govener Spring
I zip tied my govener spring, goes faster and quicker accelleration. Did not cut out at full throttle, so a guess it did not hit rev limmiter. Thanks to all for great tweeks to do .
View ArticleHelp with model and year of my G2
Serching for information about a yamaha cart that I just bougth, I found that may be is a G2A, but I dont know the year model. Can any one help me with this? Also I need to know what dou you think...
View ArticleValvetrain geometry, proper setup
So i am very early on with building my Lifan, literally in the "this time next winter" stage. I plan on running my 420 close to stock all this first season and next November or so doing a teardown&...
View ArticleClub Car 460 install throttle/switch box interference
Here's the deal-- 1993 CC DS, 6 inch lift. Installing the VC 460 with the Vegas carts kit but the carb/intake studs hit the throttle/Microswitch box. Any reason not to raise the engine up with spacers,...
View ArticleClub Car Light Problem
I have a 2004 48V DS electric Club Car that all lights stopped working simultaneously, 2 headlights and 2 taillights. This occurred shortly after I replaced the solenoid and battery cables. Any ideas?...
View ArticleVoltage reducer, lights, stereo setup....
Took the plunge and started adding some accessories to the 2010 precedent. My stock light kit didn't work when i got it, so i hard wired them directly to a new converter... everything i've done cost me...
View ArticleBATTERY ISSUES. ..Out of ideas
Ok, so this deer season I have been dealing with faster than normal discharge time. .. That said, I guess I should begin by asking if cold weather 27-30 degrees will have noticeable affect on run time?...
View ArticleTrojan battery run time?
Yesterday, i installed a new computer and new 12 volt trojan batteries in a 05 precedent. All is workng fine. After i installed the batteries, i plugged the cart in with a brand new DPI charger fr the...
View ArticleHelp with wiring a harley 3 wire ignition
After reading about replacing a stock ignition with a Harley barrel key I found JWade79 and Sergio and hoped it may help me. However, my EZGO- TXT is not keyed through the FNR. My key/ignition has a...
View Article1990 Marathon Electric won't move but tries to.
Good evening. I had the stock Curtis controller from my cart rebuilt but the good folks at FSIP and slapped that bugger in my cart. I was all fired up to get it moving but the best I got was when I...
View Articlewtb or trade for front roof mount 99 back club car
Im in wv and need a front roof mount for my club car got a few club car parts could trade or buy thanks
View ArticleClub Car DS Shocks
I have an '86 Club Car DS. It has a lift kit on it, but not sure the make of the kit. Is it likely that it has stock size shocks on it or an aftermarket size? One of my shocks is totally burnt out and...
View Articlemodel and problem
what model please?[so i know what forum]was running perfectly now not going at all.headlight works,solenoid clicks,2 fuses i found were good.if a person sat with foot on brake and accelerator revving...
View ArticleFormer sparky CC owner looking to go to the dark side.
Friends have Yami gassers, so I think I'll join the ranks. I'm lazy, and my searches weren't turning up what I wanted. There are a few Yam gassers available close by. A '96, an '00, and a '02. Can you...
View Article24V reducer?
On my parts cart there was a 24V reducer to get 12V for lights. I have installed the lights on my project cart. It has 6V batteries, so I just hooked it to two of them for now. My question, why is the...
View Article2001 CC FE290 Engine
Running good, pulled in favor of VC460 complete kit. This is for everything I have, Engine, Drive Clutch, Driven Clutch, Belt (Nearly New), Air Box, and some extra parts like new oil filter etc etc....
View ArticleOpinions of Yamaha G2
I'm looking for a gas cart to serve as the base of art car (think small parade float). I already have an Melex electric but I'm planning to use my art car at a very isolated event in the desert and...
View Article