I have a set of wakeboard speakers similar to these pictured. you can ignore the tube bracket portion as it's not going to be used.
They are very deep welled(maybe 9 inches or so). I want to cut a few inches off the well/enclosure and then just epoxy bond it back together just to shorten the depth.
Any suggestions on getting a straight/flush cut so there are no/minimal gaps when placing back together?
The only power cutting tools I have are radial saw, scroll saw, jigsaw, oscillating tool, and a dremel with cutting bits. The rest are just hand tools, hacksaw, dovetail saw, carpenter say, tiny coping saw.
Any suggestions on how to straight cut it?
thanx:-)
They are very deep welled(maybe 9 inches or so). I want to cut a few inches off the well/enclosure and then just epoxy bond it back together just to shorten the depth.
Any suggestions on getting a straight/flush cut so there are no/minimal gaps when placing back together?
The only power cutting tools I have are radial saw, scroll saw, jigsaw, oscillating tool, and a dremel with cutting bits. The rest are just hand tools, hacksaw, dovetail saw, carpenter say, tiny coping saw.
Any suggestions on how to straight cut it?
thanx:-)