I have a 2006 EZGO, 36 volts, with the PDS drive system that started going into slow mode. When put in diagnostic mode, I get only the 1-3 beep Speed sensor fault code. The controller is a Curtis 73326G07.
1. Local dealer sold me a solenoid, saying it was dropping out and causing the problem. Didn't fix it.
2. Sent the controller off to be checked, they said it was bad, repaired and sent it back to me.
3. While waiting on the controller to return, I replaced the speed sensor & magnet.
4. Installed rebuilt controller, cart ran fine for about 200 yards and then went into slow mode again. Diagnostic mode again says speed sensor fault. Cart stays in slow mode.
Question: What should the speed sensor check on a digital OHM Meter and at what setting on OHM scale?
Question: What should the output be on the Throttle position sensor? One trouble shooting guide I found on line says it should be 1.5 volts max. My speed sensor goes to 2.9 volts.
Thanks for any help you could give me.
1. Local dealer sold me a solenoid, saying it was dropping out and causing the problem. Didn't fix it.
2. Sent the controller off to be checked, they said it was bad, repaired and sent it back to me.
3. While waiting on the controller to return, I replaced the speed sensor & magnet.
4. Installed rebuilt controller, cart ran fine for about 200 yards and then went into slow mode again. Diagnostic mode again says speed sensor fault. Cart stays in slow mode.
Question: What should the speed sensor check on a digital OHM Meter and at what setting on OHM scale?
Question: What should the output be on the Throttle position sensor? One trouble shooting guide I found on line says it should be 1.5 volts max. My speed sensor goes to 2.9 volts.
Thanks for any help you could give me.