Speed sensor fault again 2006 EZGO PDS
I have a 2006 EZGO, 36 volts, with the PDS drive system that started going into slow mode. When put in diagnostic mode, I get only the 1-3 beep Speed sensor fault code. The controller is a Curtis...
View Article48 volt club car charger
96 DS plug charger in and the needle will not go past 5. it use to jump way over to almost 15. I know I have an obc that I had to bypass the negative to the solenoid, but this just started recently....
View Article36 volt to 48 volt ?
upgraded contoller 400amp curtis and D&D motor, i have 2008 ez go 36volt, buying new batteries and wondering any advantage going 48 volt...and using 6 8 volt batteries ?
View Article48v 97 club car goes full power??? New guy help
Hi group I've just finished restoring a 97 club car. New batteries & cables. My problem is as soon as I press the gas pedal the cart goes full throttle. I'm talking bark the rear tires. I've looked...
View ArticleClub car
I have for sale a 2000 ds 48 volt club car. No batteries or charger. So it's a body and rear end. seats are not good, but could be recovered. Has all the body parts, but not the best looking. So my...
View Article96 txt help
Ok hope Scotty b chimes in here need help just put new batteries in the cart it ran to the charger turned off the cart now it won't move. Checked the batt volts and they are 38.1 volts to the...
View ArticleOverwatered batteries?
Came home after church today and looked like someone spilled a cup of water underneath the cart. when i went to wipe it up it felt very slippery, looked underneath and it was dripping from the battery...
View Article1988 EZGO 2 cycle "lower gear"
As you guys have seen in other posts I rebuilt my 1988 EZGO and the engine runs strong! That being said, where I live it has some big steep hills and before the rebuild the cart seemed to "change...
View ArticleGas club car solenoid click no start(Key start)
I have a 2005 club car gas cart. This is a DS model that is a key start. Recently its not been starting when I turn the key. I can hear the solenoid click but nothing happens. My battery is fully...
View ArticleBiggest engine compartment in a Yamaha?
I have this 30hp Kohler fuel injected, liquid cooled engine. It's huge and this got me to thinking. Which Yamaha cart has the most room for a larger engine? Both side to side and back to front. I may...
View ArticleClik here to view.
WTB Harley 3 Wheel Brake Part
I am looking for part #42501-67. It Is part #29 on the attached picture. Anyone got a junk cart they would pull on off of for me? Attached Images Capture.JPG (12.9 KB)
View Articlesteeling 6" lift kit installed/ camber messed up
I bought a steeling 6" lift kit and installed it on a 2006 club car. the installed just required to replace the spindle only. after installing tires the top of the the tire is leaning in bad on both...
View ArticleHow to test Motor Part #3
Just an update but first thanks to everyone who helped! I had it tested! The case and field magnets are good but the armature is bad it is shorted. He showed me the bad wire loop he spotted it after he...
View ArticleAre my wires big enough
So I have a lifted cart/buggy that I recently replaced the motor due to the lack of torque on hills to an upgraded 36-48volt high torque motor I bought offline. With the new motor it does better on...
View Article1988 EZGO Marathon Noise Issue
1988 EZGO Marathon, with EC25-2PG motor, serial number indicates 1987 motor. Not lifted, starting with upgrades slowly. First post, lots of info on the site, but trying to figure out where to start...
View ArticleWTB 96 TXT parts
Looking for a driven clutch, the one on the axle, as well as a FnR switch assembly for a 96 TXT gas.
View Article2008 Ydre Will Not Move
I have a 2008 YDRE car at the golf course I work at that is being troublesome. It has been running fine all this season and then today wouldn't run. All of our carts are on chargers all night so I came...
View ArticleReplacing Trojan T-1275 12v with Marine Deep Cycle
I have 4 12 volt Trojan T-1275 deep cell batteries in my 2008 Yamaha Electric Drive. Looking for a cost-effective alternative to replacing them with new 1275s. Someone suggested getting 12 volt deep...
View ArticleClik here to view.
Needed EZGo Part Discontinued. Replacement thoughts?
Guys, I am restoring an older EZGo 36V cart, probably from the late 60s / early 70s. This is a multiple solenoid resistor cart that uses a five terminal switch. See pic. My switch is worn out and needs...
View Article1991 EZGO Marathon Stalling Issues
Hello all! I have a 1991 Marathon 2 cycle that is having a strange issue. When its cold I can run it around for 5-10 minutes then it bogs down until I come to a complete stop. After I come to a...
View Article