Started out w/ a Plain Jane 02 DS 48V w/ New Trojan T-875
Jakes 6in AA Arm Lift Kit,
ITP mud-Lites 11x10-22 Rear 8x10-22 Front
Re-Wired entire Cart to 2GA
FSIP 700Amp Controller
HD F&R and Solenoid
Front Carry Rack.
48V-12V Converter to run LED's and 12V charging station under Dash
Haven't installed the 22in Cree LED light bar yet trying to figure out how to mount it to the Front Rack.
Recovered the seats w/ Camo Cordura (I know it doesn't match)
Paint Job via...Redleg Natural Camo Stencils
Gun rack (little wobbly) I'm trying to figure out how to Sturdy it up. Maybe another Plate underneath the floor to give it more back bone.
Also have my new Plum Quick High Torque motor outside my door ready to install next weekend.
Also have gotten my Flexy Flares and will install them also. Dang that thing can sling some mud...
I bought the hitch receiver and the ATV carrier from Harbor freight but it is WAY to flexible.. afraid it would bend the frame just driving down the roads. need to figure a way to beef that up. Please leave any suggestions you might have for this.
Like to give a shout out to Scotty B. for his help and also to Dave (I know he's on here somewhere) at Kenco in Nacogdoches TX (where I bought the cart) for pointing out that the "firewall" I bypassed when I re-wired the cart is actually the OBC and it doesn't charge real well when you do that. :oops::oops::oops:
Jakes 6in AA Arm Lift Kit,
ITP mud-Lites 11x10-22 Rear 8x10-22 Front
Re-Wired entire Cart to 2GA
FSIP 700Amp Controller
HD F&R and Solenoid
Front Carry Rack.
48V-12V Converter to run LED's and 12V charging station under Dash
Haven't installed the 22in Cree LED light bar yet trying to figure out how to mount it to the Front Rack.
Recovered the seats w/ Camo Cordura (I know it doesn't match)
Paint Job via...Redleg Natural Camo Stencils
Gun rack (little wobbly) I'm trying to figure out how to Sturdy it up. Maybe another Plate underneath the floor to give it more back bone.
Also have my new Plum Quick High Torque motor outside my door ready to install next weekend.
Also have gotten my Flexy Flares and will install them also. Dang that thing can sling some mud...
I bought the hitch receiver and the ATV carrier from Harbor freight but it is WAY to flexible.. afraid it would bend the frame just driving down the roads. need to figure a way to beef that up. Please leave any suggestions you might have for this.
Like to give a shout out to Scotty B. for his help and also to Dave (I know he's on here somewhere) at Kenco in Nacogdoches TX (where I bought the cart) for pointing out that the "firewall" I bypassed when I re-wired the cart is actually the OBC and it doesn't charge real well when you do that. :oops::oops::oops: