Yamaha G16 gas battery
I was looking at a group size 24 battery for my g16, is 800 cca way too much for a cart or will it be fine and not cause any damage. its the autocraft marine/ rv starter battery at advance auto. I run...
View ArticleNew guy looking to buy a used cart-opinions
Hey guys been reading stuff and trying to absorb info but then when I think I know something its wrong or I just get confused..anyways need some help. Looking at CC and Ezgo 48v setups 2000 and newer...
View ArticleWTB: RXV under $3000 - MD/VA/DC area
I am looking for an RXV single seater completely stock for a project. Can pickup if somewhat local. thanks.
View ArticleClik here to view.
Paint and Rust on cables
It looks like my resistor cart has been painted and the resistor cables have paint on them. The cables also look old and rusty on the speed control panel as well as the motor. If I clean these up will...
View ArticleJerky take off
92 DS is jerky on take off. I have good $50 belt from cart parts plus. I moved engine to tighten belt, no help. Sent from my Lenovo TAB 2 A7-30F using Tapatalk
View ArticleClik here to view.
Are These Good Batteries
You guys have helped me a lot before - so thanks again. I'm upgrading for the wife - getting rid of a older 36v I've managed to keep running. I found a newer 48v RXV with 1 year old batteries -...
View Article1982 g1
thank you for the help i can find parts listed for all g1,s but the 82 witch i have some body has to still have a top end or two for it let me know where to look thanks buzzdone
View ArticleLight Options
Is there any kind of a battery powered light that mounts to the roof post, roof, (or somewhere) for occasional use at night when necessary. Used only on private property. I don't use the cart enough at...
View ArticleTXT with DCS Controller will not Go
Have TXT with DCS Controller that won't go. With key turned on and accelerator pressed solenoid will click but cart will not move forward or backward. Also solenoid stays energized until key is turned...
View ArticleClik here to view.
New to this site
So here is The Beast! I've been told it's a 1974 HD that has an unknown make/model 4 wheeler front suspension grafted to the original HD frame. The whole cart has been lifted and sits about 16" off the...
View Articlemotor type and size
Need to know what Type motor and how much H.P motor came out on the 2016 club car electric Thanks
View ArticleNew to me GXT1500
Just got this machine and know little about it.I did find a Operations-Service manual for it.Serial #000233,MFG Code J3187 which I believe makes it a 1987 model.Are these referred to as something else...
View Article48v club car charger
I havn't been here for awhile so here goes, 2008 club car fist batteries wouldn't charge, volts too low , charged each batt seperatley, plugged in my charger and it started to charge but only down to...
View ArticleBaby Moon Hub caps
Does anyone know of a BABY MOON hubcap that fits a 10" CC wheel??:help:
View ArticleClik here to view.
Painted my 2010 Yamaha Drive top today
Read and read and read till my eyes bled, and finally landed on a strategy for painting my plastic top. Washed with Dawn and hot water, dried overnight then red Scotch Brite both sides inside and out....
View Article79 Engine swap
I bought a 79 HD gas cart not long ago. It didn't run when I bought because the reed stop screw came off, fell in the crank case and locked up the engine. I did a half-a$$ rebuild on it just to get it...
View ArticleCarburetor insulator 295cc
Is there a cross reference part for the insulator. I have a 295cc and need a new insulator mine is cracked. Part number 26637g01. I'd like to buy local if I can but no local dealers open on weekends
View ArticleSlows Dwn
01 CC 48 volt IQ starts off fast in fwd then slows dwn to 7 or 8 mphs Batteries are good have changed speed sensor Q magnet has a small crack would this cause car to act this way. Thanks
View Article2004 G22E Controller Upgrade to Alltrax
I recently purchased a 2004 G22E that I was assured ran great. Of course I got home and it didn't. I replaced all of the batteries, f/r switch, key switch, accelerator safety switch, and solenoid....
View ArticleClik here to view.
2001 ezgo pds controller
This 2001 pds I bought has a curtis pmc controller in it. P/N 73326g02 36 volt Sent from my SM-G900T using Tapatalk
View Article