Will other model parts fit an Ezgo Marathon
I am doing a restore on an 89 Marathon. It I am in need of a bag well liner and front cowl. Does anyone know if the parts for any other model will fit on my cart. I'd prefer a cowl that will accept...
View ArticleGrounding
As far as I can tell I have a 1987 X 4 the last ownr wired in 2solenoids instead of 1 I am no electrician but I thought I had it figured out and then cooked the wire between the two solenoids...
View Article2014 CC precedent without ERIC??
Just saw a 2014 with a powerdrive 3 and saw another 2014 next to it with the Eric charging system...my question is, when did they make the switch to the Eric? I had thought that all 2014 precedents...
View Article72' Harley Golf Cart Engine Upgrade Suggestions?
We just purchased a 72' Harley Golf Cart with a 2 stroke engine. The standard nature of a 2 stroke engine is not exactly what will work to cruise around our neighborhood and the Country Club. It's just...
View ArticlePDS cart with speed chip --what about the magnet?
Got a 2002 ezgo stock PDS cart ( push button f/r). Cart runs ok, and has a freedom speed chip , and it has a ge motor. Although i get about 17 mph with the speed chip, i was told if i change the magnet...
View Article95 36v car won't move, not the solenoid...
Hey everyone, new here and I am searching my butt off but wanted to post as well in case anyone has some quick advice. So I just acquired a 95 cart and it won't budge. I am reading about 33 volts on...
View ArticlePOS G3 jetting
Question: when mixing fuel in a 2 stroke g3 golf cart, what should I change my main and pilot jet to? Back story: I got a 1980s sun classic for free years ago (4 or 5). I noticed it uses minimal gas...
View Articlefuel pump repair
So today I pulled the fuel pump and found the common blown bottom diaphragm. Has anyone tried to make there own diaphragm for this, or am I the only one crazy enough to try it ? If you have, I would...
View ArticleMy review of Plowman's Riot Kit
I have an '06 G22E with a 6" lift, 22" tires and a rear seat. Our campground has some fairly steep hills from the pond to the lodge and the pool to the upper sites. I installed the kit a couple of...
View ArticleClik here to view.
OEM Yamaha sliding sheave--NEW
Yamaha sliding sheave w/ grease seals. OEM part. New, in the package. $75 to your door...
View Articleaxle problems
I have a 81 g1 stretched 42 inches, on 23 inch tires been 4 years now with no problems. now I keep braking axles two just this summer is there something in the diff causeing this or what do I check any...
View Article2006 TXT stopped while I was driving
I just bought a 2006 TXT PDS 36V. It looked like a good deal and something I could take my time working on. I can see already I'll be in the red. Anyway this afternoon I was backing down my driveway...
View ArticleQuestions regarding CC charger options...
I have considered dumping the OBC and PD charger on my 2008 1/2 Precedent. The stock controller is working just fine and I have no immediate plans to replace it. I just read a recent thread concerning...
View ArticleHow to slow down an electric cart?
the campground I'm at has several rental electric golf carts. The speed limit is 6mph at the campground and the carts do the normal 14-15mph. the weekenders that rent them tend to run them at full...
View ArticleLED bulbs in a 2Five
I put LED bulbs into the stop tail lights of my 2Five. I put LED bulbs in hoping it would increase range slightly by decreasing load. But Now, when I use the turn signals I get both bulbs blinking not...
View ArticleStuddering issues at low throttle
So when I go under full acceleration the cart runs just fine but when I drive around with the pedal barely pressed down or stop and go it wants to studder. I've noticed that the solenoid is super hot...
View Articlewhat year is my golf cart
I have an amf-harley Davidson 3 Wheel gas golf cart.Can't find the age of it.The serial number is 3B16710H6.I'm trying to find the correct spark plug for it.Any help would be appreciated.
View Article48 volt CC no reverse sometimes
Batteries all read fine changed motor back to the factory motor and now sometimes reverse won't work at all or if it does work it's very jerky , any ideas ? I've cleaned the forward and reverse...
View Article