neighbors 2002 club car
anyway he has a stock 2002 48v and he wants to make it a little faster, any suggestions:mrgreen:
View ArticleG16 running slow
my 2002 was running 21mph before losing keyway in secondary clutch (had a growling noise so i took it apart after adding grease) re installed the clutch with new woodruff key and greased it after...
View ArticleDriven Clutch
So I was out riding around tonight and came upon a hill that I usually have no trouble climbing and my cart actually stopped and wouldn't climb it. I am also getting this "squeal" and have been for a...
View ArticleDriven clutch "power" spring.
I just ordered one of the red power springs for my driven clutch. It comes with the little tool to press the spring down. Is there anything special to know before I take it off and install it? Do I...
View ArticleRXV intermittent run / no run
2012 RXV With back wheels off the ground it will briefly run. It sounds like something is binding at the motor. When pedal is depressed in FWD or REV the motor spins the wheels really slow for 2-3...
View ArticleOpinions on New Controller for a Newbie
Need to get a new controller so I'm looking for opinions on what to get. Cart is a stock 2011 RXV. The OEM controller is like $1200 but the shop that is working on it says I can get a much better one...
View ArticleWho sells longer than stock TAV2 belts?
I'm doing a 212cc conversion on my electric Club Car, and am putting the driven pulley on a jackshaft, so I'll be needing a belt about 8" longer than the stock belt
View ArticleCustom Dash
I'm wanting to build my own dash. Post some pics of your custom dash's so I can steal your ideas Thanks
View Article93 ds new igniter had spark lost it
Put a new igniter on worked for about 30 mins now no spark ,I'm guessing rpm limiter went any advice would be great also tried to disconnect ground well I thi k it was the ground no luck any advice...
View ArticleG2 still having problems.
I'm still having some issues with my cart. I've nailed down most of the obvious problems like intake, fuel, valve adjustment. It starts right up but runs terrible. Sometimes it acts like the timing is...
View ArticleSprocket for 1993 EZGO
Alright, so I just removed the electric motor from my 1993 EZGO Marathon, and the next step is to get a sprocket for the input shaft on the electric axle. My questions are, What sprocket do I need (I...
View Article1988 EZGO over heating or vapor lock
I have a 1988 Ez go with a 2pg robin. Just rebuilt the lower and upper end. Also installed a new carb and fuel pump. New seals bearings everything. It will run fine but when u stop and then start again...
View ArticlePower cuts out FWD to RVRS visa versa?
Hey Guys, just finished wiring up my TXT in my custom build. Running a 30A voltage converter off the 36v series of batts. From the converter I'm running a car stereo and LED light kit. I wired the 12v...
View ArticleClik here to view.
It's coming along..
Engine rebuild, new engine case, new crank and crank shaft, rebuilt drive clutch, rebuilt driven clutch, new battery, and new seats! Sent from my iPhone using Tapatalk
View Article400 ex front suspension and brakes on ezgo txt
Anything I should know before I start ? Looking to widen the ex frame and use the factory a-arms to achieve the width I need. Thanks for any advice. Mike
View ArticleClik here to view.
Electric to gas conversion
Hello everyone I recently converted my 1990 Ez go to a harbor freight 420cc 13 hp engine, what I did was a live axle set up in the rear. New problem is I keep throwin chains off my alignments are all...
View Article2000 Yahama G19E questions
Hello, New here. I've been looking for a 4 seat golf cart to use as a pit vehicle at the racetrack. I came across a 2000 G19E today for $300. It's in very good shape with nothing visibly wrong with it,...
View ArticleClik here to view.
Electric to gas conversion HELP!!
Hey all, I recently did a 420cc 13 hp harbor frieght motor swap in my 1990 Ez go. It has a 5" lift with a live axle set up like a go cart. Problem in having now is I keep tossin the chain off my...
View ArticleClik here to view.
Limo questions for more knowledgeable members
So guys, hers the question I have. A older couple down the street from me has a nice lifted limo with jakes kit, tired, and such. It is a gas with Kawasaki engine. They do not like the size and have...
View ArticlePole Barn VS. Steel Building?
Alright, let's hear it. What are the pros and cons of each and what made you decide to pick one over the other when building your workshop/ garage? Insulated or non insulated? And also input on the...
View Article