1983 EZ GO 2 Stroke
I have a car the takes a while to start once it sits for a while. Once it starts up there is a strong fuel smell like it is flooding and it doesn't run well. The carb has been removed and cleaned. The...
View ArticleNeed help with jakes drop axle lift kit...ASAP!
Installing jakes drop axle lift kit for 05 ezgo txt gas cart. Problem am having is the tie rod has to mount from bottom of spindle due to taper hole for tie rod. This will make the tie rod hang way to...
View Article1997 EZGO TXT motor removal
I have a 1997 EZGO electric DCS that I need to remove the motor so that I can replace. Looking at it from underneath it doesn't look like the motor will pass between the frame and axle, so I'm trying...
View ArticleVolt meter
I have a 05 club car which i hooked up a volt meter , straight to batteries. Pos and neg. now can i run that to my accesry kit intead? Sent from my iPhone using Tapatalk
View ArticleClub car speed
Hi all new to the forum. I have 2010 club car precedent with a lift and 22x10-14 rims and tires. I just wonder is 10 mph top speed normal for this kind of set up? Seems a little slow to me? Thanks
View ArticleClik here to view.
Help in need of a clutch!
Hey everybody, It's been awhile since I've been here glad to see everybody's doing good I'm in need of a little experience with gas motors. Attached you will see pictures of my new car and the motor...
View ArticlePDS Troubleshooting couple of questions
I have 6 EZGO TXT Carts, 3 are DCS and and 3 are PDS. Is there a trouble shooting test out there similar to the one posted for the DCS that indicates the correct voltage within each location? I have a...
View ArticleTotal Charge 20484 Operation
Getting close to getting this old 36 Volt Resistor drive 1986 running. Got the new batteries in and all the cables replaced. I got the factory Total Charge 20484 green front charger with it. Plugged it...
View ArticleSolenoid does not engauge
Cart does not run. Cannot get solenoid to operate. I get full pack voltage on all 4 posts of the solenoid. I checked pins 5/6/9 and 10 and get full battery pack voltage on all. I checked pin #10 (blue...
View Article244 cc Teardown
Im new to this forum. I started to teardown my 1980's EZGO 2 stroke 244cc Engine.It wasn't getting fuel when i purchased it so after looking online its said to change crank seals. So since its never...
View ArticleSo is it really worth the cost to go fast.
After doing a Google search, I ended up on a cart website with all the go fast goodies for a sparky DS by accident. Let's me see, motor $500, controller $400, and on, and on. I've been reading all of...
View ArticleClik here to view.
need help on pricing first project
Started as workhorse ended up as mod txt. Heavy leaf springs jakes long travel lift. Custom seat covers new oem body complete tune up and gaskets on 350cc robin motor complete powder coated diamond...
View ArticleClik here to view.
1995 DS to MCOR4 Conversion - AM293201
I would like to try to give a little back to this forum as a way to repay for all of the information that I have gained here over the years. So I thought I would post this information about how my...
View ArticleA arm ends for long travel
I'm planning on building a long travel setup for my cart. I'm having trouble finding parts. I'm thinking of using my existing spindles so that end won't be a problem. I can't find anywhere with the...
View Article86 marathon exhaust pipe
My pipe is junk and I am having trouble finding a new one........anywhere! Am I missing something? Any suggestions where I can get one? Anyone have any luck getting an exhaust shop to make one for you?
View ArticleFan side crank seal
One of the screws holding the coil plate on is stripped. Any suggestions on getting it out?
View ArticleAll of a sudden...click, click, click goes the right front wheel?
Hello all! Hope I can get some clues/help as to what is going on... Wife took the cart for a spin and came back with the report that the front right wheel is clicking? The sound is definitely from the...
View ArticleWTB:camo wrap
Looking for some good camo wrap at a good price to install on my Club Car. Also looking for a set of fender flair.
View Article1980 Ez go marathon
Hi everyone, ok I have a 1980 ez go marathon 3 wheel I am working on restoring. I have hit a confusing issue. On a good set of 36 volt (or even a 12 volt truck battery for that matter) hooked straight...
View Article