Jump starting a CC electric cart
Ok, So my friend-girl has a later model club car precident. Somehow the pack discharged below the nominal voltage to kick in the charger (which I do not know the threshold). I tested the pack today and...
View ArticleClik here to view.
Need to add a towing hitch -I think...
Need to add a hitch to my cart. Been looking through the the threads here, but figured I would start my own. Wanna pull our new smoker around the yard. Not sure of the tongue weight yet but it weighs...
View ArticleYamaha G14e - Controller or Solenoid... thoughts?
HI All, First post after introduction. I picked up a Yamaha G14e and am starting to refurbish it. It had sat for a couple years and just got all new batteries, new battery tie cables, back seat and...
View ArticleRXV runs in neutral ! CG / Hi tech ??
OK, this is a continuance of the problem ihave been trying to solve for months. 2008 RXV Today i installed a known good controller in this cart, but that made no difference as to the cart will not run...
View Articleez go 6 to1 gear
My cart went 25 mph till I needed to rebuild the 95 motor, Now it spits and sputters at 21 mph and that is at half throttle. There is no more governor adjustment left. will changing the gears to 6 to 1...
View ArticleNew Build (first) - 1995 Club Car DS
First time cart owner, new to the forum. First of all thank you for all the good detail that I have been able to sift through. I started with a 95 Club Car DS (ingrersoll rand), which I believe is a...
View Article1" lift kit?
Working on my project and I just put 12" wheels and low profile tires on it. The cart sags some and as a result, when turning or going up a hill, the tires will rub on the rear fenders. Should try...
View Article1992 Marathon lighting questions
I have a 1992 Marathon (electric) that I'm hooking up headlights on. I know you can't use the chassis for a ground. But that means you have to find headlights that are not grounded thru their own...
View Article1988 marathon ez-go motor issue?
Good day everyone, My name is R.C. and I am new to this site. After searching around I feel like this place could really help me since I am always buying carts. Maybe I could help someone in the future...
View ArticleClik here to view.
Running Wire Thru Top Supports
Thought I'd share an easy way to run wire thru top support brackets. Drill holes in support large enough for the weight and wires. Don't drill in bends, makes it hard to fish wire. Crimp a split shot...
View ArticleShe's a Smoker!
Ive been going over some things on my g11 (has a g9 engine) the last few days, adjusted valves, fixed the vacuum control valve issue etc, well now the thing smokes like a chimney after it has sat for...
View ArticleDS 48 volt, Ser# AA0329-300865
Service Manual would be handy trying to chase down why pre charge resistor is cooking. I suspect controller has shorted MOSFET/Transistors. Going for a Beer while I wait for Help.
View ArticleClik here to view.
On board computer burnt spot
I just removed my rear body for painting and found a burnt part on what I think is the on board computer. What would have cause this and do I need another one? Attached Images image.jpg (112.6 KB)
View ArticleClub car precedent
Club car precedent 2008 won't move. I changed the Mcor the speed sensor still won't move it will hope forward a little. Any ideal Thanks Lines2256
View ArticleHeadlight not working after Altrax 500 XCT Installed
Before I had a new Altrax XCT 500amp installed on my 2006 Club Car Precedent my headlight worked. The light had moisture in it so I took it off and let the dealer install the controller. My new light...
View Article? for gas mixture
Hello all, I have a new to me 91 EZ GO was wondering what the gas to oil mixture is on this 2 cycle. Guy I got it from says the engine was newly rebuilt, He said he put 1 oz to 1 gallon. Any info thanks.
View ArticleClik here to view.
Rear seat platform trailer hitch reinforcement
I know there's a thread or two with a custom/necessitative solution or two for reinforcing the rear seat platform hitches, which of course bolt only to the platform making them weaker than ideal. Those...
View ArticleNeed new top end??
Hello all new to the forum here as many others I have read and learned quit a bit. A buddy of mine gave me a 78 HD four wheel cart that didn't run it has 3 flat tires body is OK needs a little work but...
View Article1991 EZGO motor location
Just bought a 91 EZGO electric marathon,motor is in center(not over rear end).also has controller,pot box etc, I am familiar with this year model,but have never seen motor being in center with...
View ArticleCam gear mounting to camshaft
Good evening, I have a 2006 club car with an FE350. It quit running one day and after trouble shooting I realized the valves weren't moving. I pulled the engine and found the rivets snapped off holding...
View Article