Runs for a second...
2004 ds with regen. (tow switch under seat) Cleaned all terminals. Charges normally. Headlights work. With ignition switch on and in Forward or Reverse, depressing the accelerator causes the normal...
View ArticleClik here to view.
1987 Club car, Charger Super hot and loud, Random fuse hanging in cart???
Just purchased a 1987 club car. Plugged it in to charge it for first time, charger got super hot and loud, opened under the seat and this is what I find. There is an orange/red wire that goes from the...
View ArticleWhat size lift and what kind of lift???
Hi folks, I just picked up a 02 cc 48volt with high speed motor. It is sitting at stock height and I absolutely can't continue to keep it there. I know there is a search option on here however it...
View Articleneed a Speed Controller G9
I found out why my voltage was screwed up the speed controller board is no good dont want to spend 1000 or more golf cart its not worth the money JF3-86510-11-00 Moter Controll Unit Assembly (note...
View ArticleReverse buzzer sounds even when not in reverse
2010 par car. Reverse buzzer sounds when ever the key is turned on even when not in reverse. Flashing code 2
View ArticleG2 upgrades
Ok everyone finally have my g2 put back together and top speed is 18.8mph on stock tires. Already have a comet primary clutch, and open element air filter. What is the best bang for the buck on...
View Articledpi charger help
I just bought a Yamaha 48v cart installed brand new Trojan battery's cart runs great but the charger that came with cart does nothing no lights come on when plugged to outlet no buzzing no nothing it's...
View ArticleClik here to view.
relocated choke cable
OK, I do not like the choke and ignition being under the front of the seat. A little hard for me to use them, so I moved them. I put the ignition switch under the left side of the dash like an old...
View ArticleClik here to view.
Wire from solenoid to controller appears to be melting, what could be the cause?
I don't know when it happened, I've put about 25 miles on this build. The jacket looks like it's melted and a little brittle. Should I go with a bigger wire, or is it because I'm temporarily running a...
View ArticleCowl trim - blind nuts
I have lost some of the cowl trim nuts that slide into the inside track. Haven't been able to locate a part# or accurate description but need to get a few replacements. Anyone know where to get them?...
View Articlewill a polaris secondary fit on g2 yamaha rear end?
I picked up a cut up Yamaha g2? cart and want to put in one of my 500cc polaris engines. I am just wondering if the polaris secondary will fit on the Yamaha rear end.Thought I seen that iw would posted...
View ArticleCV Tech clutch???
Don't know if anyone here can help but on my cart with the Vanguard I have a CVTech Powerbloc clutch. Runs excellent except for the noise it makes at idle. All this time I was hearing a clacking noise...
View ArticleClik here to view.
Broken spacer
The spacer between the carb and motor has broken for the second time on my G14. I had put a cone filter like the one shown . I noticed the filter was moving a good bit . Do you think the filter...
View ArticleClik here to view.
Sometimes wonder what Shop owners drive?
I know we are all curious from time to time, what do the guy who works on them drive. Like does a Ferarri tech drive a Ferarri or what? While I for sure don't drive a Ferarri but I do have a nice...
View ArticleClik here to view.
Motor getting HOT
I have a 98 Club Card DS 48 volt. I just installed a new AMD 5.5hp motor and it gets really hot after running for about 15 minutes. I bought the motor because it said it would run with stock...
View ArticleReversing Contactor??
Just started the install of scotty B's reversing contactor on a ezgo series cart. The problem is that the instructions say that the M- on the controller goes to the A2, But the way my cart is wired up...
View Article1990 DS Electric does not Respond to Accelerator
I have a 1990 Club Car DS 36v electric in reasonably good condition mechanically and aesthetically. It had been very well maintained when I bought it, had new batteries installed 7/2014 and has always...
View ArticleClik here to view.
Driven clutch issues avoided
I am very glad I decided to put a new belt on my Marathon. While taking the old one off, I noticed that the outer sheath was loose. The rivets had made the holes in the sheath oblonged, and the sheath...
View ArticleRXV Stop/Go Issue...again
Okay, sorry for long post but want to provide as much details as possible: 2008/9 RXV 48volt cart A month ago while driving down the road the brakes started to engage randomly making the cart come to a...
View Article