XCT 500 programing
So I've been playing with the programing. Actually, my computer friend is. We ended up making the throttle leneier setting very shallow for 70 % of the screen. Then it steeply goes up to max. We set...
View ArticleFirst upgrade!!
First upgrade on my cart is on its way! I ordered up a new alltrax XCT500 controller package from Scottyb. He was tons of help and very patient with this new guy!!
View ArticleNo lights!
I have just recently Cleaned the battery terminals, and used the red stuff on them. I have also replaced the MCOR ( I think that's what it's called). The wiring looked okay. Lights worked fine before I...
View Article700amp controller melting wires
I just got a 2000 48volt ds and it's had money thrown at it my problem is it's melting the side from the wires and coming loose glowing red at the motor and I'm really almost to my wits end with this...
View ArticleIs this OEM or Aftermarket??
The seller says its OEM but for the price its hard to beleive. Is there anyway to identify a OEM carb over a aftermarket?? Thanks http://www.ebay.com/itm/Ezgo-golf-ca...567945?vxp=mtr
View ArticleShock swap
Can't believe the cost for front shocks on electric g2/ g9 yamaha ...is there an alternative than using an OEM equivalent??
View ArticleNeed to tow Ezgo
I have a DCS with run/tow switch. Cart has broken down, do I just need to switch to tow, to safely tow the cart home? Thx Skip Sent from my Nexus 6 using Tapatalk
View Articlecharger won't go below 9 amps?
2001 ds 48 volt. 4 year old batteries. Charger won't shut off, stays at 5 amps . So today, i started out by measuring battery voltage. Voltage was 48.9 volts. I plugged a charger in, and let it run for...
View ArticleHybrid Harley/Columbia:Have to choke to start when hot.
I have a columbia par car from the 80's with an older harley tillotson carb, air filter, and muffler. Last year I replaced the old crank case seals on the recommendation of this forum. I recently...
View ArticleBroken clutch can't remove
I really need some good advice on this one. 07 Club Car DS. Attempting to remove the drive clutch that has been severely damaged by others. Removal tool is of no use. Had to cut clutch front half off....
View ArticleNew member First Par Car
Picked her up for $500 and she runs and drives. As far as i can tell it is a 96+ Havent found the VIN. When i got it, it took way too fast, i adjusted the throttle and found a good spot that i was...
View ArticleEZGO DCS dead
I have an EZGO DCS with Alltrax DcX 400 with upgraded selinoid...motor is stock. Was driving it and it lost power and started smelling a burn smell... Smell seems to be around the controller area. Took...
View ArticleYamaha excel V 540 into a G9 cart
Newbie here but I've been trying to search and read as much as I can. But I'm new so a few questions. Can I cap off or get rid of the direct oil injection if I just use mixed gas? How important is it...
View ArticleEZGO medalist front cowl
Can someone tell me if I can put a txt front cowl on a medalist cart. I've heard they were interchangeable.
View ArticleJakes shifter?
I bought a Jakes shifter at a swap meet but have no idea if it will fit my g14? Anyone have any pics of the correct shifter arm to see if i have the correct one? Thanks
View ArticleClik here to view.
Workhorse front hubs are not 4/4 bolt pattern
I've got a '98 workhorse with front hubs at have a 3.75" bolt hole pattern. The rears are 4-on-4. Is this normal? Has a previous owner swapped out the originals? I'm eventually looking to add a drop...
View ArticlePiston ring set cc390
Hallo everyone I've recently worked on a 390 and I've almost changed everything on the engine. A question Does piston rings have a proper position? In the new piston I found out 2 different colored...
View ArticleRHOX Headlights. Yamaha Drive G29
Has anybody replaced your stock headlights, and dimmer switch on a stock G29 Drive? They have a red wire {hot}, a black wire {ground}, and a white wire. What is the white for?
View ArticleClik here to view.
Lithium Nissan Leaf conversion x 2
Getting close to finalizing this project. After watching sportcoupe's conversions and almost bought some of his batt. just couldn't swing it at the time. I bought a pack in dec. to convert mine and a...
View Article